Page 12 - WIRE-BOND Products Catalog

WIRE-BOND M A S O N R Y T O S T E E L S T U D

RJ-711 Adjustable Veneer Anchor

#2401
Plate is available in either 14 gauge or 12 gauge;
adjustable hook is made of 3/16” diameter wire. Accomodates up
to 4” of insulation.
Available in mill galvanized, hot dip galvanized and
stainless steel. Hook lengths are 3-1/4”, 4-1/4”, and 5- #2402
1/4”. Hook adjustments are maximum of 1-1/4” up or
down. Also available for walls with 1”, 1-1/2”, 2”, 2-
1/2”, 3”, 3-1/2” and 4” insulation. Test data provided
upon request.

The WIRE-BOND® RJ-711 with 3/16” adjustable tie
meets the Brick Industry of America’s requirement of a
maximum deflection of less than .05 inches
( 1.2mm ) when tested at an axial load of 100 pounds in
tension and compression. Extensive test results available
upon request.

HCL-711 Anchoring System #2411

• HCL-711 Anchoring system installs quickly and easily
on exterior walls with brick veneer while providing
positive contact with metal stud and avoiding damage to
wallboard.
• The HCL-711 System moves the dew point from within
the stud to near the outer face of the rigid insulation,
reducing potential corrosion at the screw locations.
• Especially useful in high wind environments and seismic
areas D,E and F where wallboard is installed between the
steel stud and insulation.
• Simplified installation procedure saves on labor costs.
• Compatible with the WIRE-BOND® Clip System used
in seismic zones.
SQUARE GRID:

DESCRIPTION AND SIZES: With the metal studs spaced at 16″ intervals,
the system provides a 16″ squared grid. This
• “LEGS” to accommodate 0, 1″, 1-1/2″, 2″, 2-1/2″, 3″, 3-1/2″ and 4″ is accomplished with two easy steps:
thicknesses insulation.
• The “legs” of the HCL-711s provide the platform for the insulation. 1. First, 8-foot-wide insulation is installed as
This eliminates potential insulation damage and improves thermal a guide from the footer of the wall. The 16″
performance. R value is maintained. height of the insulation indicates where the
• The installer does not have to penetrate varying amounts of next horizontal line of HCL-711s will attach
insulation while guessing for direct contact with the stud. at the vertical line of wallboard fasteners.
• The pintles serve to secure the insulation to the exterior wallboard. 2. The insulation is then inlaid snugly
The simplified installation procedure saves on labor costs. between the legs of the uniform horizontal
lines of HCL-711s.

12 For Material Conformance / Submittal Sheets, see wirebond.com WIRE-BOND 800 - 849 - 6722